Accuracy and precision of quantitative DCE-MRI parameters: How should one estimate contrast concentration?

Nicole Wake, Hersh Chandarana, Henry Rusinek, Koji Fujimoto, Linda Moy, Daniel K. Sodickson, Sungheon Gene Kim

Research output: Contribution to journalArticle

2 Scopus citations

Abstract

Introduction: Pharmacokinetic parameters derived from dynamic contrast-enhanced MRI (DCE-MRI) data are sensitive to acquisition and post-processing techniques, which makes it difficult to compare results obtained using different methods. In particular, one of the most important factors affecting estimation of model parameters is how to convert MRI signal intensities to contrast agent concentration. The purpose of our study was to quantitatively compare a linear signal-to-concentration conversion (LC) as an approximation and a non-linear conversion (NLC) based on the MRI signal equation, in terms of the accuracy and precision of the pharmacokinetic parameters in T 1 -weighted DCE-MRI. Materials and methods: Numerical simulation studies were conducted to compare LC and NLC in terms of the accuracy and precision in contrast kinetic parameter estimation, and to evaluate their dependency on flip angle (FA), pre-contrast T 1 (T 10 ) and arterial input function (AIF). In addition, the effect of the conversion method on the diagnostic accuracy was evaluated with 36 breast lesions (19 benign and 17 malignant). Results: The transfer rate (K trans ) estimated using LC and measured AIF (mAIF) were up to 38% higher than the true K trans values, while the LC K trans estimates with the presumed AIF (pAIF) were up to 7% lower than the true K trans values, when FA = 45°. When using a small FA, such as 12° the LC K trans with pAIF had least sensitivity to the error in T 10 compared to the K trans estimated using LC with mAIF, and NLC with pAIF or mAIF. The breast DCE-MRI study showed that both LC and NLC K trans were significantly different (p < 0.05) between the malignant and benign lesions. The effect size between benign and malignant values as measured by Cohen's d was 1.06 for LC K trans and 1.02 for NLC K trans . Conclusion: The present study results show that, when precontrast T 1 measurement is not available and a low FA is used for DCE-MRI, the uncertainty in the contrast kinetic parameter estimation can be reduced by using the LC method with pAIF, without compromising the diagnostic accuracy.

Original languageEnglish (US)
Pages (from-to)16-23
Number of pages8
JournalMagnetic Resonance Imaging
Volume52
DOIs
StatePublished - Oct 2018

Keywords

  • Contrast agent concentration
  • Dynamic contrast-enhanced MRI
  • Perfusion
  • Pharmacokinetic model

ASJC Scopus subject areas

  • Biophysics
  • Biomedical Engineering
  • Radiology Nuclear Medicine and imaging

Fingerprint Dive into the research topics of 'Accuracy and precision of quantitative DCE-MRI parameters: How should one estimate contrast concentration?'. Together they form a unique fingerprint.

  • Cite this